Resistor, Capacitor, Inductor. Lets spend little bit time here

Building the second for Hardware.

Yes, I am creating the system for Hardware design. Systemized Hardware design. This is not a new thing to me. I used to create a lot of design calculations and a workspace for working with Hardware design. Now, just given the Name.

I built a spreadsheet to accommodate the basics of Resistor, Capacitor, and Inductor.

https://docs.google.com/spreadsheets/d/1v-yvq9giT3YS7RCG-4z0br8Nf434k1cxVi4Dyw3yGqg/edit?usp=sharing


Lets go from the Basics....


Comments

Post a Comment

Popular posts from this blog

Step by step DCM Flyback Design calculation - Part 1

Image
 I have been trying to design the flyback convertor for very long time. Each time I came across different different material and got confused like anything and drop. So this time, I have decided to take only one material and follow it completely start to end, and then proceed with further materials and designs. I came across Infineon technologies material for designing DCM flyback convertor. I started with understanding the  formulas and step by step procedure. Flyback convertor generally we go if power needed is around 100W Below is the basic specifications needed to start designing flyback convertor. Input voltage range Output Voltage Output current/ Load current Output Ripple voltage Efficiency I think it is better to make one flow diagram to represent all the steps than by writing all the steps. I thought of making formulas also as a flow diagram. But  I looks messy. So I will mention them as step by step as below. Step 1: Calculating maximum input Power The maximum i...
Read more

OP-AMP Differential Amplifier circuit and derivation

Image
Recently I have been studying the opamp circuits and their application.  One of those circuits is a differential amplifier circuit. I wanted to make the article for the derivation of the differential amplifier circuit. Lets dive into the topic. Differential amplifier is nothing but the combination of the inverting and non-inverting amplifier circuit. The output equation of inverting amplifier is given by `Vo1=-\frac{R2}{R1}\times V1`   --- (1) The output equation of the non-inverting amplifier is given by `Vo2=(1+\frac{R2}{R1})\times V2` ---(2) Applying superposition theorem, the output of combining inverting and non-inverting amplifier is given by `Vo=Vo1+Vo2` ---(3) `Vo=-\frac{R2}{R1}\times V1 +(1+\frac{R2}{R1})\times V2` ---(4) The equation of the differential amplifier is given by `Vo=K (V2-V1)` ---(5) From the equation (4), the amplication factor K can be derived if `-\frac{R2}{R1}=(1+\frac{R2}{R1})` It can be done by adding the voltage divider circuit at the input o...
Read more

Filter circuits working- Lets start with RC filter

Image
Now, it's time to explore the workings of the filter circuits. I have been thinking about where to start for too long. But we have to start it anyway; that's what matters. So the filter circuit is basically a voltage divider circuit. In case of resistance, based on the resistance value, the voltage gets divided, and we get the voltage across the resistance. In the above example, a 12V 10Hz AC signal drops to a 6V AC signal across the resistor R2, which obeys Ohm's law. Simple. In the case of a capacitor, the capacitive reactance depends on the frequency of the signals. Means that capacitive reactance increases with a decrease in frequency. The equation for the RC low-pass filter is given in the image below.  Let's try to calculate the output voltage. For the above circuit, we are getting an output voltage of around 6.22V across the capacitor for the 2 kHz signal. Let's try to simulate the same, and let's see the result. Let's play with different frequency va...
Read more